It is difficult to get noise free signal in microwave frequency range of 30 gigahertz and above, Fujitsu has announced millimeter wave low noise signal generator circuit for automotive radar and other ...

A very simple thyristor signal generator circuit which uses a single thyristor, two resistors, a capacitor and a mini-loudspeaker. Once the circuit is switched ti a current source, current flows ...

I have wanted to make a pulse generator for years. I know you can buy perfectly good ones, but not if you want non-overlapping outputs to drive the mosfets in synchronous-rectified dc-dc converters.

Test applications often call for a clock signal. Rather than tie up a function generator, you can build a programmable clock generator with just two ICs. You can then control the clock generator with ...

Fujitsu Laboratories has developed a CMOS-based millimeter-wave signal generator capable of modulating its frequencies across a wide band of 76-81 GHz at the world’s fastest speeds. This development, ...

[Debraj] needed a simple signal generator for a project he was working on, but didn’t have one handy. He found that the easiest and cheapest way to get clean, reliable signaling was by using something ...

This article is part of the Ideas for Design Series: Vol. 3, No. 7. This simple, robust, and low-cost signal generator, based on the LM386 power amplifier IC, provides a trio of audio-band signals ...

The new APO Pyrofuse from SCHURTER provides active safety for high-voltage systems up to 1000V/400A. A micro gas generator disconnects the circuit within less than 2ms in case of a fault signal – ...